Thrubeam Type Laser Detection Sensor

IB series

Catalogs查看目录

SpecsThrubeam Type Laser Detection SensorIB series

模型

IB-01

IB-05

IB-10

IB-30

Image

光源

Wavelength

660 nm (Visible light semiconductor laser)

Laser Class

Class 1 Laser Product (IEC 60825-1, FDA (CDRH) Part 1040.10*1)

Installation distance

0 to 2,000 mm78.74“

0 to 300 mm11.81"

测量范围

Ø1mmø0.04”(Installation distance 0 to 300 mm11.81")
ø1 to 2.5 mm (Installation distance 300 to 2,000 mm11.81" to 78.74")

5毫米0.20"

10毫米0.39"

30 mm1.18"

Sampling cycle

12,500次/秒。(80μs)

最小检测目标

Ø8μmø0.31 Mil(Installation distance 0 to 300 mm11.81")
ø8 to 50 µmØ0.31至1.97 mil(安装距离300至2,000 mm11.81" to 78.74")*2

ø0.05 mmØ0.002“*2

ø0.1 mmØ0.004“*2

Ø0.2毫米ø0.01"*2

重复性

5 µm0.20 Mil(distance 0 to 300 mm11.81")*3

5 µm0.20 Mil*3

10 µm0.39 Mil*3

温度特性

±0.2%的F.S./°*4

±0.1 % of F.S./°C (±5 µm0.20 Mil)*4

±0.1%的F.S./°(±10μm0.39 Mil)*4

±0.1 % of F.S./°C (±30 µm1.18 Mil)*4

Operating indicators

激光排放警告指示灯:绿色LED

环境抵抗力

Ambient light

Incandescent lamp: 5,000 lux, Solar light: 10,000 lux

Incandescent lamp: 5,000 lux, Solar light: 5,000 lux

Incandescent lamp: 10,000 lux, Solar light: 10,000 lux

Ambient temperature

0 to +40 °C32到104°F(No freezing)

0到+50°C32到122°F(No freezing)

相对湿度

35 to 85 % RH (No condensation)

抗振

10至55 Hz,双幅度1.5毫米0.06", 2 hours in each of the X, Y, and Z axis

Material

Case

PBT

镀锌压铸

Lens cover

Glass

电缆

PVC(2米6.6')

Weight

约。140 g

约。180 g

约。220 G.

约。510 G.

*1The classification for FDA (CDRH) is implemented based on IEC60825-1 in accordance with the requirements of Laser Notice No. 50.
*2Value when measuring the target (white diffuse object) at the middle of the transmitter and receiver position, and at the center of the measurement range.
*3When distance between transmitter and receiver is set to 300 mm11.81"而且光线在150 mm的位置处半屏蔽5.91“from receiver. Deflection width (±2σ) when sampled for 30 seconds with an average number of times set to 64 times.
*4当发射器和接收器之间的距离设置为100 mm时3.94"and full light is received.

Back to top

模型

IB-1000

IB-1500.

IB-1050

IB-1550

Image

类型

DIN rail mount

Panel mount

DIN rail mount

Panel mount

主要单位/扩展单位

Main unit

扩展单位

Head compatibility

Yes

Display

Display resolution

0.01 %, 0.1 %, 1 % (switchable)

Display range

–99.999 to 99.999, –99.99 to 99.99
-99.9至99.9,-99至99(可切换)

数字显示方法

Dual7-segmentDisplay.
Upper level: 5 red digits
Lower level: 5 green digits

Dual7-segmentDisplay.
Upper level: 2-color (green/red) 5 digits
Lower level: 5 green digits

Dual7-segmentDisplay.
Upper level: 5 red digits
Lower level: 5 green digits

Dual7-segmentDisplay.
Upper level: 2-color (green/red) 5 digits
Lower level: 5 green digits

Operating indicators

Judgment indicator: 2-color (green/red) LED (HI, GO, LO)
Bank indicator: Green LED x 4
Laser emission warning indicator: Green LED
其他:绿色LED x 8,红色LED x 3

Analog output voltage

±5 V,1至5 V,0至5 V输出阻抗100Ω*1

模拟电流输出

4 to 20 mA Maximum load resistance 350 Ω*1

控制输入

Bank switch input, zero shift input

不n-voltage input*2

控制输入

Zero shift input

激光发射停止输入

定时输入

Reset input

Adjust input

Control output

判断输出(检查输出)

Open collector (NPN/PNP switchable, N.O./N.C. switchable)*3

Power supply

Power consumption

2400 mW or less (at 30 V, 80 mA max.)*4*5(包括模拟电流输出)

2550 MW或更少(30 V,85 mA最大)*4*5(包括模拟电流输出)

2400 mW or less (at 30 V, 80 mA max.)*4*5(包括模拟电流输出)

2550 MW或更少(30 V,85 mA最大)*4*5(包括模拟电流输出)

电源电压

10 to 30 VDC, including ripple (P-P) 10% Class 2 or LPS*4

供应主机*4

环境抵抗力

Pollution degree

2

Ambient temperature

-10 to +50 °C (No freezing)

相对湿度

35 to 85 % RH (No condensation)

抗振

10至55 Hz,复合幅度1.5毫米,每个用于X,Y,Z轴2小时

Material

Main unit case/Front panel: polycarbonate, keytop: polyacetal, cable: PVC

Weight

约。150 g (including accessories)

约。170克(包括配件)

约。140 g (including accessories)

约。165 g (including accessories)

*1±5 V, 1 to 5 V, 0 to 5 V, or 4 - 20 mA should be selected.
*2四根外部输入线被分配有所需的输入。
额定无电压输入:电压2 V或更少,关闭电流0.05 mA或更低
Rated voltage input: Max. input rating 30 V or less, ON voltage 7.5 V or more, OFF current 0.05 mA or less
*3额定NPN开放收集器输出:最大。100 mA / CH(20 mA / Ch连接时连接,延长单位),30 V或更小,剩余电压1 V或更低
Rated PNP open collector output: Max. 50 mA/ch (20 mA/ch when expansion units are connected), power voltage or less, residual voltage 2 V or less
*4Use with the over current protection device which is rated 30 V or more and not more than 1 A.
*5不包括负载的功耗。
The power consumption with expansion units installed is the total of each amplifier unit’s power consumption.
Example: When using one main unit (IB-1000) with two expansion units (IB-1050) (2400 mW X 1) + (2400 mW X 2) = 7200 mW

Back to top